General
-
Allow flexibility to create a system one line diagram for off grid & hybrid systems
Overlay charge modes on SOC & kWh graphs
1 vote -
voltage graduation dod volts
change dod volts to tenth of a volt changes
1 vote -
Display AGS Timers
Display AGS Timers
1 vote -
Show Outside Temperature on Dashboard Graph
On the bar chart in the Dashboard, add the option to have a line graph on the right hand side that shows the outside temperature (instead of the battery temperature). This would be extremely helpful since my solar output and load usage is largely dependent upon the outside weather (due to A/C or heat).
3 votes -
0 votes
-
Alert methods
An alert page for system parameters should include email notifications, as well as an open URL for running REST commands into a home automation controller, IFTTT, or any push style notifications.
3 votes -
Ability to bookmark a specific dashboard.
Ability to bookmark a specific dashboard so you don't always need to click around and navigate to the dashboard page after logging in.
1 vote -
0 votes
-
Location display for site in continous movement
Allow disabling the site latitude and longitude coordinates or displaying the weather information. Unfortunately the lat/log setting is static. So, when the site is a remote vehicle OpticRE does not display the correct continuously changing location data.
1 vote -
External Load switching
I would like to switch loads in an out with external set of relays depending of mate3 conditions
ie
- power surplus = switch in load "A"
- power shortfall = switch out load "B"5 votes -
Add fixture of Automatic status of pv generation on daily base like sma system
Add fixture of generating Automatic status email of pv generation on daily base like sma system
1 vote -
Add to chart grid outages and excess solar indicators
Graph grid power outages and excess solar availability on the dashboard chart.
(e.g. green + marker on hours with sleeping charge controllers, red x markers on hours with no grid available)
2 votes -
MAC Address Change
Enhancement Request: In the unlikely event that a MATE3 should fail and need to be replaced, there should be a mechanism for editing the MAC address within OPTICS RE and keeping the old history associated with the new replacement MATE3.
I can see at least five possible ways to implement this:
1. By OPTICS staff allowing multiple MAC addresses to be supported, or by OPTICS staff changing the MAC address on record whenever a device is replaced in the field.
2. At the OPTICS end allowing the MAC address to be editable there, with some verification that it is not…14 votes -
Easy AUX control
Add a button to System Tools area that can be assigned to an AUX for easily turning loads on-off remotely.
3 votes -
More user settings!
More user defined settings--for example, for legacy inverters, the capability for user to enter appropriate info. Also for legacy inverters and off-grid users, capability to add info about generator use (the grid isn't involved, so power must either be solar or generator).
2 votes -
Show full 20-second data, not just hourly!
You're getting data from me every 20 seconds. How can it possibly be that you only display hourly averages? Please show the full detail I'm paying to send you!
6 votes -
Selecting Data and Summing them
Highlight specific times of the day and calculate the same numbers as shown in the top right of the browser
1 vote -
4 votes
-
Power flow chart for DC only system
Power flow chart for DC only system
1 vote -
0 votes
- Don't see your idea?